The type of transport system used for an irrigation project is often determined by the source of the water supply. If a surface water supply is used, a large canal or pipeline system is usually required to carry the water to the farms because the reservoir is likely to be distant from the point of use. If subsurface water drawn from wells is used, a much smaller transport system is needed, though canals or pipelines may be used. The transport system will depend as far as possible on gravity flow, supplemented if necessary, by pumping. From the mains, water flows into branches, or laterals, and finally to distributors that serve groups of farms. Many auxiliary structures are required, including weirs (flow-diversion dams), sluices, and other types of dams. Canals are normally lined with concrete to prevent seepage losses, control weed growth, eliminate erosion hazards, and reduce maintenance. The most common type of concrete canal construction is by slip forming. In this type of construction, the canal is excavated to the exact cross section desired and the concrete placed on the earth sides and bottom. Pipelines may be constructed of many types of material. The larger lines are usually concrete whereas laterals may be concrete, cement–asbestos, rigid plastic, aluminum, or steel. Although pipelines are more costly than open conduits, they do not require land after construction, suffer little evaporation loss, and are not troubled by algae growth.